Quick Installation Guide TEG-160WS TEG-240WS
Table ofofContents Table Contents English ...................................................................................................... 1. Before You Start ................................................................................ 2. Hardware Installation ........................................................................ 3. Web Management Utility .................................................................... 1 1 2 3 Troubleshooting ...............................................
1. Before You Start Package Content TEG-160WS/TEG-240WS Quick Installation Guide Utility & User Guide CD-ROM 2 Mounting Brackets with Screws Power Cord System Requirements Web Browser: Internet Explorer (5.0 or above), Netscape (6.
2. Hardware Installation Note: After hardware installation is complete, use the Web-based Smart Utility to configure the TEG-160WS/TEG-240WS. To access the Web-based Smart Utility, open your web browser, and enter the default IP Address http://192.168.0.1 and default password "admin". Make sure your computer and the TEG-160WS/TEG-240WS are configured to the same network segment. 1. Connect the Power Cord to the rear of the TEG-160WS/ TEG-240WS and then to a power outlet. 2.
3. Web Management Utility ote: If you would like to easily discover all the Web Management Switches on the network, assign IP Address, change the password, and upgrade to new firmware, then install the Web Management Utility. Follow the steps below. For Windows User 1. Insert the Utility & User’s Guide CD-ROM into your computer's CD-ROM Drive and then click Install Utility. 2. Follow the Installation Wizard instructions. Click OK. 3.
4. Click Discovery, and then doubleclick the Switch that appears in the Discovery List. 5. Click the Switch in the Monitor List and then click Configuration setting. 6. Configure the IP Address, Subnet mask, Gateway, and Password. Click Set.
. Click OK. 8. Click Web access. 9. Type in your Password and then click Login. For more information regarding the Web-based Smart Utility configuration and advanced settings, please refer to the User's Guide included on the Utility CDROM or TRENDnet's website at www.trendnet.
Troubleshooting Q1: After connecting the TEG-160WS/TEG-240WS to a power outlet, the LEDs do not turn on. A1: Check the connection of the power cord to the TEG-160WS/TEG-240WS and the power outlet. Also check that the power outlet is receiving power. Q2: After installing the Web-Management Utility, I clicked Discovery and the Utility is unable to discover the TEG-160WS/TEG-240WS. What should I do? A2: Make sure that the TEG-160WS/TEG-240WS is powered on and that all connections are secure.
Certifications This equipment has been tested and found to comply with FCC and CE Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical and electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with you Local Authority or Retailer for recycling advice.
TRENDnet Technical Support US . Canada Toll Free Telephone: 1(866) 845-3673 24/7 Tech Support Europe (Germany . France . Italy . Spain . Switzerland . UK) Toll Free Telephone: +00800 60 76 76 67 English/Espanol - 24/7 Francais/Deutsch - 11am-8pm, Monday - Friday MET Worldwide Telephone: +(31) (0) 20 504 05 35 English/Espanol - 24/7 Francais/Deutsch - 11am-8pm, Monday - Friday MET Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.