Operation Manual

© Copyright 2013 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-732BR
29
Note: The Public Port can be assigned a different port number than the Private Port
(also known as port redirection), however it is recommended to use the same port
number for both settings. Please refer to the device documentation to determine
which ports and protocols are required.
LAN Server: Enter the IP address of the device to forward the port (e.g.
192.168.10.101).
Note: You should assign a static IP address to the device or use DHCP reservation to
ensure the IP address of the device does not change.
Add: Saves a new virtual server entry.
Delete: Removes an existing virtual server.
Update: Modifies an existing virtual server.
Cancel: Discard changes to an existing virtual server.
Example: To forward TCP port 80 to your IP camera
1. Setup DynDNS service (See DynDNS section).
2. Access TRENDnet IP Camera management page and forward Port 80 (see product
documentation)
3. Make sure to configure your network/IP camera to use a static IP address or you can
use the DHCP reservation feature (see “
Set up DHCP reservation” on page 25).
Note: You may need to reference your camera documentation on configuring a
static IP address.
4. Log into your router management page (see “
Access your router management page
on page 21).
5. Click on Access, and click on Virtual Server.
6. In the list below, click the pre-defined virtual server entry named Virtual Server HTTP.
Note: The selected item will be highlighted in yellow when selected.
7. The fields will be populated with the selected pre-defined virtual server entry.
8. Click Enabled to turn on this virtual server.
9. Next to Name, you can enter another name for the virtual server, otherwise, leave
the default name.
10. Next to Protocol, make sure TCP is selected in the drop-down list.
11. The Private Port and Public Port, make sure port number 80 is configured for both
settings.
12. Next to LAN Server, enter the IP address assigned to the camera. (e.g.
192.168.10.101)
13. To save the changes, click Update.
Special Applications
Access > Special AP
Special applications (also called port triggering) is typically used for online gaming
applications or communication applications that require a range of ports or several
ports to be dynamically opened on request to a device on your network. The router will
wait for a request on a specific port or range of ports (or trigger port/port range) from a
device on your network and once a request is detected by your router, the router will
forward a single port or multiple ports (or incoming port/port range) to the device on
your network. This feature is not typically used as most devices and routers currently