User's Guide

Table Of Contents
© Copyright 2014TRENDnet. All Rights Reserved.
44
TRENDnet User’s Guide
TEW-739APBO
o WEP Key #: Enter HEX or ASCII format WEP key value; the system supports up to 4
sets of WEP keys.
WPA-PSK (or WPA2-PSK): WPA (or WPA2) Algorithms, allows the system accessing
the network by using the WPA-PSK protected access.
o Cipher Suite: By default, it is AES. Select either AES or TKIP cipher suites
o Group Key Update Period: By default, it is 600 seconds. This time interval for
rekeying GTK, broadcast/multicast encryption keys, in seconds. Entering the time-
length is required.
o Master Key Update Period: By default, it is 83499 seconds. This time interval for
rekeying GTK, broadcast/multicast encryption keys, in seconds. Entering the time-
length is required.
o Pre-shared Key: Enter the pre-shared key; the format shall go with the selected
key type.
WPA-Enterprise (or WPA2-Enterprise): The RADIUS authentication and encryption
will be both enabled if this is selected.
WPA General Settings:
o Cipher Suite: By default, it is AES. Select either AES or TKIP cipher suites
o Group Key Update Period: By default, its 3600 seconds. This time interval for
rekeying GTK, broadcast/multicast encryption keys, in seconds. Entering the time-
length is required.
o Master Key Update Period: By default, it is 83499 seconds. This time interval for
rekeying GTK, broadcast/multicast encryption keys, in seconds. Entering the time-
length is required.
o EAP Reauth Period: By default, it's 3600 seconds. Set WPA2 PMKID cache
timeout period, after time out, the cached key will be deleted.
o Pre-Authentication: By default, it's “Disable”. To Enable is use to speed up
roaming before pre-authenticating IEEE 802.1X/EAP part of the full RSN
authentication and key handshake before actually associating with a new AP.
Radius Server Settings :
o IP Address: Enter the IP address of the Authentication RADIUS server.
o Port: By default, it’s 1812. The port number used to communicate with RADIUS
server.
o Shared secret: A secret key used between system and RADIUS server. Supports 8
to 64 characters.
o Accounting RADIUS Server: Enable to set Account RADIUS server.
WEP 802.1X: When WEP 802.1x Authentication is enabled, please refer to the
following Dynamic WEP and RADIUS settings to complete configuration.