Quick Installation Guide

Note:

1. The initial configuration should be completed in a testing environment with two

TEW-740APBO's approximately 15 ft. (5 meters) apart from one another.

2. Configure and connect the devices before mounting.

WDS Setup

Included PoE injector

1. Connect one end of a network cable into TEW-740APBO #1.

2. Connect the opposite end of the network cable to the P+DATA OUT port on the Power over

Ethernet Injector.

3. Connect one end of another network cable to the 10/100 DATA IN port on the Power over

Ethernet Injector.

4. Connect the other end of a network cable to your computer's Ethernet port.

5. Connect the power adapter into the Power over Ethernet Injector. Then connect the power

adapter into a power outlet. (EU models have an on/off switch. Please move the power switch

to the “On” position).

6. Assign a Static IP address to your computer's network adapter in the subnet of 192.168.10.x

(e.g. 192.168.10.50) and a subnet mask of 255.255.255.0.