User Guide

© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO
10
8. At the Password Setup page, enter your new password in the New admin Password
field and once again in the Check admin Password field to confirm, then click Save to
apply the new password settings.
Note: It is recommended to change to a strong admin password. This is the password
that will be used to login to the access point management configuration web page.
9. In the access point management web page, click on System and click on LAN.
10. Under Static IP, enter the IP address settings below, then scroll down and click Save
to apply the settings. After changes are applied, you will need to login to the new IP
address assigned.
Note: Please note that if your existing network IP subnet is different. You must assign IP
addresses available in your IP subnet to the access points accordingly.
TEW-740ABO #1 IP Configuration
IP Address: 192.168.10.50
IP Netmask: 255.255.255.0
IP Gateway: 192.168.10.1
11. Click System and click on Operating Mode. In the list, select WDS and click on Save
& Reboot to apply the settings.
12. Click on Wireless and click on General.
You can choose to change the Channel settings but they must match on both access
points to establish a point-to-point WDS configuration. For this example, we will leave
as the default channel 6. If you decide to change it, make sure to scroll down and click
Save to apply the setting.
13. Click on Wireless and click on Virtual AP. For VAP0, click on Edit.
14. You can choose to change the ESSID (Wireless Network Name) settings but they
must match on both access points to establish a point-to-point WDS configuration. For
this example, we will leave as the default setting TRENDnet7400_2.4GHz.