User Guide
Table Of Contents
- Product Overview
- Setup & Installation
- Note the Wireless MAC Addresses
- TEW-740APBO #1 Configuration
- TEW-740APBO #2 Configuration
- Verify Point-to-Point Configuration/Connectivity
- Grounding Wire Installation
- Waterproof Kit Installation
- Mounting Hardware Installation
- Completed Point to Point Setup and Pole Mount Installation Example
- Installation Tips
- Application Modes
- AP Mode Configuration
- WDS Mode Configuration
- Repeater Mode
- CPE + AP Mode Configuration
- System Management
- Technical Specifications
- Appendix
© Copyright 2016 TRENDnet. All Rights Reserved.
16
TRENDnet User’s Guide
TEW-740APBO
Mounting Hardware Installation
Pole Mounting
Note: The pole mounting clamp supports poles with a maximum diameter of 101 mm (3.98 in.)
1. Align the mounting bracket with the hole on the unit and secure it with the M6x8 screw and washer provided.
2. Slide the two provided pole mounting clamps around the pole. Place the mounting bracket at the desired height and position.
3. Secure the TEW-740APBO to the pole mounting bracket using mounting clamp screws.
4. Adjust the orientation of the access point as necessary.