User Guide
Table Of Contents
- Product Overview
- Setup & Installation
- Note the Wireless MAC Addresses
- TEW-740APBO #1 Configuration
- TEW-740APBO #2 Configuration
- Verify Point-to-Point Configuration/Connectivity
- Grounding Wire Installation
- Waterproof Kit Installation
- Mounting Hardware Installation
- Completed Point to Point Setup and Pole Mount Installation Example
- Installation Tips
- Application Modes
- AP Mode Configuration
- WDS Mode Configuration
- Repeater Mode
- CPE + AP Mode Configuration
- System Management
- Technical Specifications
- Appendix
© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO
43
o Operating Mode: The mode currently in service.
o Host Name: The name of the system.
o Host Description: A description of the system.
o Firmware Version: The current installed firmware version.
o Firmware Date: The build time of installed firmware.
o Device Time: The current time of the system.
o System Up Time: The time period that system has been in service since last
reboot.
o ETH1/ETH2MAC: Ethernet MAC address of the access point.
o Wireless MAC: Wireless MAC address of the access point
o CPU Loading: The CPU loading of the access point
o Memory Used: Memory usage of the access point.
LAN Information: Display total received and transmitted statistics on the LAN
interface.
o Ethernet Connection Type: The connection applied on the access point.
o IP Address: The management IP of system. By default, it’s 192.168.2.254.
o IP Netmask: The network mask. By default, it’s 255.255.255.0.
o IP Gateway: The gateway IP addresses and by default, it’s 192.168.2.1.
o Primary DNS: The primary DNS server in service.
Wireless Information: Display total received and transmitted statistics on available
Virtual AP.
o WiFi: Wireless status of the access point.
o Band: Operating wireless band of the access point.
o Channel: Operating channel of the access point.
o Current Tx Power: Transmit power of the access point.
o Data Rate: Current wireless data rate of the access point.
Extra Information
Users could pull out information such as Route table, ARP table, MAC table, Bridge table
or STP available in the drop-down list from system. The “Refresh” button is used to
retrieve latest table information.
Route table information: Select “Route table information” on the drop-down list
to display route table. The access point could be used as a L2 or L3 device. It
doesn’t support dynamic routing protocols such as RIP or OSPF. Static routes to
specific hosts, networks or default gateway are set up automatically according to
the IP configuration of system's interfaces. When used as a L2 device, it could