User Guide
Table Of Contents
- Product Overview
- Setup & Installation
- Note the Wireless MAC Addresses
- TEW-740APBO #1 Configuration
- TEW-740APBO #2 Configuration
- Verify Point-to-Point Configuration/Connectivity
- Grounding Wire Installation
- Waterproof Kit Installation
- Mounting Hardware Installation
- Completed Point to Point Setup and Pole Mount Installation Example
- Installation Tips
- Application Modes
- AP Mode Configuration
- WDS Mode Configuration
- Repeater Mode
- CPE + AP Mode Configuration
- System Management
- Technical Specifications
- Appendix
© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO
46
Repeater Mode
When Universal Repeater mode is activated, the system can be configured as an Access
Point and Client Station simultaneously. This section provides information in configuring
the Client Bridge+Universal Repeater mode with graphical illustrations. The access point
provides functions as stated below where they can be configured via a user-friendly web
based interface.
External Network Connection
Network Requirement
It can be used as a Client Bridge or Universal Repeater to receive and repeat wireless
signal over last mile applications, helping WISPs deliver wireless broadband Internet
service to new residential and business customers. In this mode, the access point is
enabled with DHCP Server functions. The wired clients of the access point are in the
same subnet from Main Base Station and it accepts wireless connections from wireless
client devices.
Universal Repeater mode network Configuration
Configure LAN IP
Here are the instructions to setup the local IP Address and Netmask.
Please click on System -> LAN and follow the below setting.
Mode: Check either “Static IP” or “Dynamic IP” button as desired to set up the
system IP of LAN port.
Static IP: The administrator can manually setup the LAN IP address when static IP is
available/ preferred.
o IP Address : The IP address of the LAN port; default IP address is 192.168.2.254
o IP Netmask : The Subnet mask of the LAN port; default Netmask is 255.255.255.0
o IP Gateway : The default gateway of the LAN port; default Gateway is
192.168.2.1
Dynamic IP : This configuration type is applicable when the access point is
connected to a network with the presence of a DHCP server; all related IP
information will be provided by the DHCP server automatically.
o Hostname : The Hostname of the LAN port
DNS: Check either “No Default DNS Server” or “Specify DNS Server IP” button as
desired to set up the system DNS.
o Primary: The IP address of the primary DNS server.
Main
SSID: Repeater_Main_AP