User Guide

Table Of Contents

TRENDnet User’s Guide

TEW-740APBO

Bottom View

 Reboot/Reset Button – You will need to unscrew the protective cover or

disconnect the RJ-45 waterproof kit if it is installed to gain access to this

button. Press and hold this button for 2 seconds and release to reboot the

device. Press and hold this button for 10 seconds and release to reset the

device to factory defaults.

 Power LED – The indicator will turn when the device is powered on.

 WLAN Connection Quality Indicators – The connection quality indicators will

turn on depending on the connection quality during installation. These

indicators can help to assist with optimal placement and positioning during

mounting/hardware installation.

Good Connection Quality

Better Connection Quality

Best Connection Quality

 LAN Port – You will need to unscrew the protective cover to gain access to this

port. The Ethernet LAN port operates at 10/100Mbps and is also used to supply

power to the device using only the included proprietary PoE injector.

 Proprietary PoE Injector –

o POWER IN – Connect the included power adapter connector to this

input and adapter side into an AC power source to supply power to

the injector.

o P+DATA OUT – Connect an Ethernet RJ-45 cable to this output and the

other side to the device LAN port to supply power to the device.

o 10/100 DATA IN – Connect an Ethernet RJ-45 cable to this input and

connect the other to your network or directly to computer for initial

device setup.