User Guide
Table Of Contents
- Product Overview
- Setup & Installation
- Note the Wireless MAC Addresses
- TEW-740APBO #1 Configuration
- TEW-740APBO #2 Configuration
- Verify Point-to-Point Configuration/Connectivity
- Grounding Wire Installation
- Waterproof Kit Installation
- Mounting Hardware Installation
- Completed Point to Point Setup and Pole Mount Installation Example
- Installation Tips
- Application Modes
- AP Mode Configuration
- WDS Mode Configuration
- Repeater Mode
- CPE + AP Mode Configuration
- System Management
- Technical Specifications
- Appendix
© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO
61
Remote AP status
List the current status of the remote access point.
o ESSID: SSID of remote access point
o MAC Address: Display MAC address of WDS peer.
o RSSI: Indicate the signal strength of the respective WDS links.
o TX/RX SEQ: Transmit and receive sequence.
o TX/RX Bytes: Transmit and receive bytes
o Status: Display current association status of remote access point
CPE + AP Mode Configuration
When CPE+AP mode is chosen, the system can be configured as a Customer Premises
Equipment (CPE). This section provides detailed explanation for users to configure in the
CPE+AP mode with help of illustrations. In the CPE+AP mode, functions listed in the
table below are also available from the Web-based GUI interface.
External Network Connection
Network Requirement
It can be used as an Outdoor Customer Premises Equipment (CPE) to receive and repeat
wireless signal over last mile application, helping WISPs deliver wireless broadband
Internet service to residents and business customers. In the CPE+AP mode, the access
point is a gateway enabled with NAT and DHCP Server functions. The wired and wireless
clients connected to the access point are in different subnet from those connected to
Main Base Station, and, in CPE+AP mode, it accepts wireless connections from wireless
client devices.