User Guide
Table Of Contents
- Product Overview
- Setup & Installation
- Note the Wireless MAC Addresses
- TEW-740APBO #1 Configuration
- TEW-740APBO #2 Configuration
- Verify Point-to-Point Configuration/Connectivity
- Grounding Wire Installation
- Waterproof Kit Installation
- Mounting Hardware Installation
- Completed Point to Point Setup and Pole Mount Installation Example
- Installation Tips
- Application Modes
- AP Mode Configuration
- WDS Mode Configuration
- Repeater Mode
- CPE + AP Mode Configuration
- System Management
- Technical Specifications
- Appendix
© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO
62
Configure CPE Setup
There are three connection types for the WAN port: Static IP, Dynamic IP, PPPoE and
PPTP,
Please click on System -> WAN and follow the below setting.
Mode: Check “Static IP”, “Dynamic IP”, “PPPoE” or “PPTP”to set up system WAN IP.
Static IP: Users can manually setup the WAN IP address with a static IP provided by
WISP.
o IP Address: The IP address of the WAN port; default IP address is 192.168.1.254
o IP Netmask: The Subnet mask of the WAN port; default Netmask is 255.255.255.0
o IP Gateway : The default gateway of the WAN port; default Gateway is
192.168.1.1
Dynamic IP: Please consult with WISP for correct wireless settings to associate with
WISP AP before a dynamic IP, along with related IP settings including DNS can be
available from DHCP server. If IP Address is not assigned, please double check with
your wireless settings and ensure successful association. Also, you may go to
“WAN Information” in the Overview page to click Release button to release IP
address and click Renew button to renew IP address again.
o Hostname : The Hostname of the WAN port
PPPoE : To create wireless PPPoE WAN connection to a PPPoE server in network.
User Name : Enter User Name for PPPoE connection
Password : Enter Password for PPPoE connection
Reconnect Mode:
o Always on: A connection to Internet is always maintained.
o On Demand: A connection to Internet is made as needed.
o Manual: Click the “Connect” button on “WAN Information” in the Overview page
to connect to the Internet.
Idle Time: Time to last before disconnecting PPPoE session when it is idle. Enter
preferred Idle Time in minutes. Default is “0”, indicates disabled. When Idle time is
disabled, the “Reconnect Mode” will turn out “Always on”
MTU: By default, it’s 1492 bytes. MTU stands for Maximum Transmission Unit.
Consult with WISP for a correct MTU setting.
PPTP: The Point-to-Point Tunneling Protocol (PPTP) mode enables the implementation of