User Guide
Table Of Contents
- Product Overview
- Setup & Installation
- Note the Wireless MAC Addresses
- TEW-740APBO #1 Configuration
- TEW-740APBO #2 Configuration
- Verify Point-to-Point Configuration/Connectivity
- Grounding Wire Installation
- Waterproof Kit Installation
- Mounting Hardware Installation
- Completed Point to Point Setup and Pole Mount Installation Example
- Installation Tips
- Application Modes
- AP Mode Configuration
- WDS Mode Configuration
- Repeater Mode
- CPE + AP Mode Configuration
- System Management
- Technical Specifications
- Appendix
© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO
64
Please click on System -> LAN and follow the below setting.
Mode: Check either “Static IP” or “Dynamic IP” button as desired to set up the
system IP of LAN port.
Static IP: The administrator can manually setup the LAN IP address when static IP is
available/ preferred.
o IP Address: The IP address of the LAN port; default IP address is 192.168.2.254
o IP Netmask: The Subnet mask of the LAN port; default Netmask is 255.255.255.0
o IP Gateway : The default gateway of the LAN port; default Gateway is
192.168.2.1
Dynamic IP: This configuration type is applicable when the access point is
connected to a network with the presence of a DHCP server; all related IP
information will be provided by the DHCP server automatically.
o Hostname : The Hostname of the LAN port
DNS: Check either “No Default DNS Server” or “Specify DNS Server IP” button as
desired to set up the system DNS.
o Primary: The IP address of the primary DNS server.
o Secondary: The IP address of the secondary DNS server.
802.1d Spanning Tree
The spanning tree network protocol provides a loop free topology for a bridged
LAN between LAN interface and 4 WDS interfaces from wds0 to wds3. The Spanning
Tree Protocol, which is also referred to as STP, is defined in the IEEE Standard
802.1d. Spanning tree always disabled on the access point. Below Figures depict a
loop for a bridged LAN between LAN and WDS link
DHCP Setup: Devices connected to the system can obtain an IP address
automatically when this service is enabled.
o DHCP: Check Enable button to activate this function or Disable to deactivate this
service.
o Start IP / End IP: Specify the range of IP addresses to be used by the DHCP server
when assigning IP address to clients. The default range IP address is 192.168.2.10
to 192.168.2.70, the netmask is 255.255.255.0
o DNS1 IP: Enter IP address of the first DNS server; this field is required.
o DNS2 IP: Enter IP address of the second DNS server; this is optional.
o WINS IP: Enter IP address of the Windows Internet Name Service (WINS) server;
this is optional.
o Domain: Enter the domain name for this network.