User Guide

© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO
72
 ESSID: Assign Service Set ID for the wireless system.
 Enable Repeater SSID: Select Enable to broadcast the repeated signal.
 Hidden SSID: Select Enable to broadcast the access point’s SSID.
 Client Isoltion: Select Enable to isolate wireless clients from each other.
 IAPP:
 Maximum Clients: Enter the amount of wireless clients allowed to connect to the
access point.
 Security Type: Select the desired security type from the drop-down list; the options
are Disable, WEP, WPA-PSK, WPA2-PSK, WPA-Enterprise, WPA2-Enterprise and
WEP 802.1X.
o Disable: Data are unencrypted during transmission when this option is selected.
 WEP Auth Method: Enable the desire option among OPEN or SHARED
o Key Index: Key index is used to designate the WEP key during data transmission.
4 different WEP keys can be entered at the same time, but only one is chosen.
o WEP Key #: Enter HEX or ASCII format WEP key value; the system supports up to
4 sets of WEP keys.
 WPA-PSK (or WPA2-PSK) : WPA (or WPA2) Algorithms, allows the system accessing
the network by using the WPA-PSK protected access.
o Cipher Suite: By default, it is AES. Select either AES or TKIP cipher suites
o Group Key Update Period: By default, it is 600 seconds. This time interval for
rekeying GTK, broadcast/multicast encryption keys, in seconds. Entering the time-
length is required.
o Master Key Update Period: By default, it is 83499 seconds. This time interval for
rekeying GTK, broadcast/multicast encryption keys, in seconds. Entering the time-
length is required.
o Pre-shared Key: Enter the pre-shared key; the format shall go with the selected
key type.
 WPA-Enterprise (or WPA2-Enterprise): The RADIUS authentication and encryption
will be both enabled if this is selected.