User Guide

© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO
76
 Private Port: A port or a range of ports may be specified as start:end; i.e. port
20:80
 Public Port: A port or a range of ports may be specified as start:end; i.e. port 20:80
.Click “Add” button to add Virtual Server rule to List. Total of maximum 20 rules are
allowed in this List. All rules can be edited or removed from the List. Click Reboot button
to activate your changes.
While creating multiple Virtual Server rules, the prior rules have higher priority. The
Virtual server rules have precedence over the DMZ one while both rules exist. Example 1
and 2 demonstrate proper usage of DMZ and Virtual Server rules.
 Example 1: All connections should be redirected to 192.168.2.12 while DMZ is
enabled. Since Virtual Server rules have precedence over the DMZ rule all
connections to TCP port 22 will be directed to TCP port 22 of 192.168.2.10 and
remaining connections to port TCP 20~80 will be redirected to port TCP 20~80 of
192.168.2.11
 Example 2: All connections should be redirected to 192.168.2.12 while DMZ is
enabled. Since Virtual Server rules have precedence over the DMZ rule all other
connections to TCP port 20~80 will be redirected to port 20~80 of 192.168.2.11.
The rule 2 won’t take effect.
Bandwidth Control
Bandwidth control allows you to control the bandwidth going through the access point.
 Service: Select Enable to turn on bandwidth control through the access point.
 Mode: Select the bandwidth control mode to use through the access point.
 Upload: Enter the upload bandwidth speeds
 Download: Enter the download bandwidth speeds
Routing
This section allows you to configure the routing of the access point.
 OSPF: Select Enable to enable OSPF setting
 RouterID: Select the ID to configure
 Network (WAN): Select to configure the WAN section, enter the area to assign
 Network (LAN): Select to configure the LAN section, enter the area to assign.
 Distribute RIP over OSPF: Check this option to use RIP protocol
 RIP Settings
 RIP Service: Select Enable to use RIP protocol
 Side: Select the network section to apply RIP.
Status
This section breaks down into subsections of System Overview, Associated Clients
Status, WDS Link Status, Extra Information and Event Log.