User Guide

© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO
81
System Management
Configure Management
Administrator could specify geographical location of the system via instructions in this
page. Administrator could also enter new Root and Admin passwords and allow multiple
login methods.
Please click System -> Management and follow the below settings.
 System Information
o System Name: Enter a desired name or use the default one.
o Description: Provide description of the system.
o Location: Enter geographical location information of the system. It helps
administrator to locate the system easier.
 Admin Password:
o New Password : Enter a new password if desired
o Check New Password: Enter the same new password again to check.
 Admin Login Methods:
o Enable HTTP: Check to select HTTP Service.
o HTTP Port: The default is 80 and the range is between 1 ~ 65535.
o Enable HTTPS: Check to select HTTPS Service
o HTTPS Port: The default is 443 and the range is between 1 ~ 65535.
o Enable Telnet: Check to select Telnet Service
o Telnet Port: The default is 23 and the range is between 1 ~ 65535.
o Enable SSH: Check to select SSH Service
o SSH Port: The default is 22 and the range is between 1 ~ 65535.
 Ping Watchdog: The ping watchdog sets the access point to continuously ping a
user defined IP address (it can be the internet gateway for example). If it is unable
to ping under the user defined constraints, the access point will automatically
reboot. This option creates a kind of "fail-proof" mechanism.
Ping Watchdog is dedicated for continuous monitoring of the particular connection
to remote host using the Ping tool. The Ping works by sending ICMP “echo request”
packets to the target host and listening for ICMP “echo response” replies. If the defined
number of replies is not received, the tool reboots the device.
o Enable Ping Watchdog: control will enable Ping Watchdog Tool.
o IP Address To Ping: specify an IP address of the target host which will be
monitored by Ping Watchdog Tool.
o Ping Interval: specify time interval (in seconds) between the ICMP “echo
requests” are sent by the Ping Watchdog Tool. Default is 300 seconds.
o Startup Delay: specify initial time delay (in seconds) until first ICMP “echo
requests” are sent by the Ping Watchdog Tool. The value of Startup Delay should
be at least 60 seconds as the network interface and wireless connection
initialization takes considerable amount of time if the device is rebooted. Default
is 300 seconds.