User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
11
16. After device saves changed and reboots, click on System and click on VLAN Setup.
17. For the first entry in the VLAN List under the action column, click Network.
18. In the IP Setup section, enter the IP Address 192.168.10.50, then click Save. In the
menu located at the top, you will be prompted to reboot the device. Click the Reboot
button and in the following page, click Reboot. When prompted to reboot, click Yes
apply changes and reboot.
Note: After the device reboots, you will need to reconnect to the access point
configuration page using the new IP address setting and login. When configuring TEW-
740APBO #2, enter the IP address 192.168.10.51.