User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
12
19. Click on Wireless and click WDS Setup.
20. Click Enabled for the WDS Setup and under Authentication, select AES. Enter a WDS
Passphrase. (8-63 alphanumeric characters)
Note: When configuring TEW-740APBO #2, the WDS passphrase must be the same
passphrase configured on TEW-740APBO #1.
21. Under WDS Client Setup, check the first entry and enter the WiFi MAC address of
TEW-740APBO #2 00:11:22:33:44:11. Then click Save. In the menu located at the top,
you will be prompted to reboot the device. Click the Reboot button and in the following
page, click Reboot. When prompted to reboot, click Yes apply changes and reboot.
Note: When configuring TEW-740APBO #2, enter the WiFi MAC address of TEW-
740APBO #1.