User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
17
TEW-740APBO2K Setup and Installation
IMPORTANT COMPATIBILITY NOTE: If you are establishing WDS bridge connections to
TRENDnet TEW-740APBO H/W: v2.0R outdoor access points, please make sure to
upgrade the TEW-740APBO H/W: v2.0R access points to firmware 2.10 or above for
WDS compatibility with the TEW-740APBO H/W: v3.0R.
When purchasing the access point bridge kit, mode TEW-740ABPO2K, by default, the
TEW-740APBO access points are preconfigured to establish a point-to-point WDS bridge
between each other using a unique predefined AES encryption key. For convenience, a
unique predefined admin password has already been assigned to both access points.
You can find the preconfigured access point settings on the wireless sticker or on the
device label beneath the cover where the Ethernet ports and LEDs are located. No
additional configuration is required. Ma
On the device label located inside, you can also find the preconfigured default settings
of each access point.
The TEW-740APBO access points will be preconfigured with the following settings:
TEW-740APBO #1
TEW-740APBO #2
IP Address
192.168.10.50
192.168.10.51
Netmask (Subnet Mask)
255.255.255.0
255.255.255.0
IP Gateway (Default Gateway)
192.168.10.1
192.168.10.1
Primary DNS
192.168.10.1
192.168.10.1
Wireless Channel (Default)
1
1
Mode
WDS
WDS
WDS Encryption
AES
AES