User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
19
4. Connect the other end of the RJ-45 network cable to the P+DATA OUT port on the
included PoE injector.
5. Connect the included power adapter to the PoE injector POWER IN on the included
PoE injector.
6. Plug the connected power adapter into a power outlet.
7. Confirm the device is powered on through the PWR LED indicator.
Note: Repeat steps 1-7 to power on and connect the second access point.
8. Assign a static IP address to your computer’s network adapter in the subnet of
192.168.10.x (e.g. 192.168.10.10) and subnet mask of 255.255.255.0.
9. Using another network cable, connect one end to the 10/100 DATA IN port on the
included PoE injector for either the first or second access point.
10. Connect the other end of the network cable to your computer’s Ethernet port.