User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
21
Ground Wire and Pole Mount Installation
1. Locate the grounding point located in bottom section of the enclosure. Using a
Phillips screwdriver, remove the ground point screw (counter clockwise) and attach the
included grounding wire to the ground point screw. Reattach the ground screw
(clockwise) along with the grounding wire. After installing the grounding wire, remove
another tab on the enclosure by gently bending back and forth until the tab is removed.
This will create the opening for the ground cable to be routed through.
Note: The ground wire may need to be cut and extended using additional ground wire in
order to reach a proper ground point.
2. Re-install the cover by lining up the guides into the notches as shown and push the
cover down until the cover clips in and is secure. After reinstalling the cover, insert the
included rubber seal in the opening as shown.
3. Insert the included fasteners through the holes located at the back of the access
point.
4. Wrap the fasteners around the pole where the access point will be installed. On the
fasteners, insert the open end into the locking mechanism and pull tight until the point
is secured.
5. After the access points are properly mounted, you can connect the grounding wires to
the proper ground points and RJ-45 cables from each access point PoE injector to your
network.