User's Guide

© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
33
Backup and restore your AP configuration settings
Utility > Profile Setting
Backup configuration settings
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click Utility and click on Profile Setting.
3. Next to Save Settings To PC, click Save.
Depending on your web browser settings, you may be prompted to save a file (specify
the location) or the file may be downloaded automatically to the web browser settings
default download folder. (Default Filename: config.bin)
Restore configuration settings
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click Utility and click on Profile Setting.
3. Next to Load Settings From PC, click Browse or Choose File.
4. A separate file navigation window should open.
5. Select the configuration file to restore and click Upload. (Default Filename:
config.bin). If prompted, click Yes or OK.
6. Wait for the device restore settings.
Reset your AP to factory defaults
Utility > Profile Setting
You may want to reset your device to factory defaults if you are encountering difficulties
and have attempted all other troubleshooting. Before you reset to defaults, if possible,
you should backup your router configuration first. If you are using are resetting an AP
from the TEW-740APBO2K Bridge Kit, the APs will default to the original predefined
settings which can be located on the device label inside the enclosure or predefined
sticker.
There are two methods that can be used to reset your device to factory defaults.
• Reset Button – Located inside the enclosure where Ethernet ports and LEDs are
located. Use this method if you are encountering difficulties with accessing your
router management page.
OR
• Management Page
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click Utility and click on Profile Setting.
3. Next to Reset To Factory Default, click Default.
Soft reboot your AP
Utility > Reboot
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click Utility and click on Network Utility.
3. Click Reboot.