User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
36
View currently connected wireless client devices
Status > Wireless Client
This page will display the wireless client devices that are currently connected to your AP.
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click Status and click on Wireless Client.
• Radio – Displays the radio the wireless client device is connected. Since the
TEW-740APBO only has one radio (Radio 0), only Radio 0 will be shown for this
model.
• MAC Address – Displays the wireless client device MAC address.
• Rate (RX/TX) – Displays the estimated receive and transmission rates at which
the wireless client device is connected.
• RSSI – Displays the estimated signal strength of the wireless client device
relative to the AP. The value is a negative number, therefore, the lower the
value, the better signal and connectivity of the client device.
View currently connected authenticated users
Status > Online Users
Only when using the guest or user authentication feature, this page will display
information about the currently connected authenticated users.
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click Status and click on Online Users.
View authentication log information
Status > Authentication Log
Only when using the guest or user authentication feature and authentication log has
been enabled, this page will displayed authentication status logs and attempts for each
VLAN.
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click Status and click on Authentication Log.
View the device system log information
Status > System Log
This page will display general device logging information about the system operation,
functions, and status.
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click Status and click on System Log.