User's Guide

© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
40
5. In the MAC Rules, select the rule action.
Only Allow List MAC – This rule only allows listed MAC addresses to connect and denies
all others.
Only Deny List MAC – This rule denies all listed MAC addresses and allows all others to
connect.
DHCP Server
System > VLAN Setup > VLAN # > DHCP Server
This feature will allow to distribute IP address automatically on the selected interface.
Typically, your network router will already be automatically distribute IP address
settings via DHCP.
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click System and click on VLAN Setup.
3. For the first entry in the list VLAN #0, under the Action column, click the arrow next to
the Network button and select DHCP Server. Review the settings below and click Save
when completing the changes.
• Mode – Enable or Disable the DHCP service.
• Start IP: Enter the first IP address of the IP address range/pool to distribute to DHCP
client devices. (ex. 192.168.10.101)
• End IP: Enter the last IP address of the IP address range/pool to distribute to DHCP
client devices. (ex. 192.168.10.199)
• Netmask: Enter the subnet mask to distribute to DHCP client devices. (ex.
255.255.255.0)
• Gateway: Enter the default gateway IP address to distribute to DHCP client devices.
(ex. 192.168.10.1)
• DNS1 IP: Enter the IP address of the primary DNS server to distribute to DHCP client
devices.
• DNS2 IP: Enter the IP address of the secondary DNS server to distribute to DHCP
client devices.
• WINS IP: Enter the IP address of the WINS (Windows Internet Name Service) server
to distribute to DHCP client devices. Typically this is used on a Windows network to
allow the resolution of computer and device names.
• Domain: Enter the domain name to distribute to DHCP client devices. (ex.
trendnet.com)
• Lease Time: Enter the time in seconds how long DHCP client devices will retain their
settings assigned by the DHCP service before expiration. Upon expiration, DHCP
client devices will initiate new requests for DHCP client settings.