User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
57
Client Bridge + AP Mode
Client Bridge mode functions similar to that of a wireless client adapter like the one built
into your notebook PC or mobile device. It wireless connects to a wireless network
provided by a wireless AP or router and bridges this connection to the device Ethernet
ports. Additionally, in Client Bridge mode, the device can function as an AP and create
another wireless network to also bridge over it’s connection from the wireless AP or
router.
Set the device to Client Bridge + AP mode
System > Mode Setup
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click System and click on Mode Setup.
3. Select Client Bridge + AP Mode in the mode drop down list. Then click Save &
Reboot.
Set the device IP address settings
System > LAN Setup
To set the IP address, gateway, and DNS settings, click on System and click on LAN
Setup. Click Save when you have completed your settings.