User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
69
DHCP Reservation/Static Lease
System > DHCP Setup
• Comment: Add a comment or name to help easily identify the device or purpose of
the DHCP static IP lease/reservation.
• IP Address: Enter the IP address from the DHCP server IP address range/pool to
permanently assign. (ex. 192.168.10.20)
• MAC Address: Enter the MAC address of the client device to assign the permanent
lease in the example format provided and click Add to add the static IP lease to the
list. (ex. 00:11:22:AA:BB:CC). Repeat to add additional static IP leases.
Configure WAN connection settings
System > WAN Setup
To setup the WAN interface connection method for the LAN1 Ethernet interface, click
on System and click on WAN Setup. The device supports Dynamic IP, Static IP, PPPoE,
and PPTP connection types. Click Save when you have completed the changes.
Note: Please check with your Internet Service Provider for the required connection
settings and configure them accordingly.
• Static IP – Your ISP requires the IP address, Subnet Mask, Default Gateway, and
DNS Server IP address settings to be manually entered and statically assigned. If
required by your ISP, specify the MAC address for this interface.
• Dynamic – Your ISP will automatically provide you the IP address, Subnet Mask,
Default Gateway, and DNS Server IP address settings. . If required by your WISP,
specify the MAC address for this interface.
• PPPoE (Point-to-Point Protocol over Ethernet)– Your ISP requires a specifically
assigned user name and password for authentication in order to establish
connectivity.
• PPTP (Point-to-Point Tunneling Procotol) - Your ISP requires a specifically
assigned user name and password for authentication in order to establish
connectivity similar to PPPoE but a different type of tunneling technology.
Verify you have established wireless connectivity by attempting to communicate to the
Internet.