User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
75
CAP (Control AP) Mode
CAP mode functions in AP mode but in addition, this mode allows you to manage,
monitor, and control other APs using the same firmware/software. You can configure
multiple settings for multiple APs at the same time, push out batch firmware upgrades
from one convenient GUI interface. The CAP Mode AP can discover and manage any CAP
mode compatible APs on any of interfaces including WDS bridged links. Note: Currently,
the only TRENDnet TEW-740APBO (H/W: v2.XR) is CAP mode firmware/software
compatible.
The diagram below displays of a group of CAP mode firmware/software compatible APs
either connected through the wired network interfaces or WDS link. One AP is
configured in CAP mode is able to discover and centrally manage all other APs in this
example scenario.
Note: You can reference the all the AP mode functions and settings in the AP mode
section. This section will primarily cover the CAP mode features only.
1. Log into your access point management page (see “Access your access point
management page” on page 28).
2. Click System and click on Mode Setup.
3. Select CAP Mode in the mode drop down list. Then click Save & Reboot.
In the top menu, a new section will be available called AP Control.