User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
5
Primary Product Application
The intended purpose and application for this product is to extend network connectivity
across long physical distances outside of an area or building that lacks local connectivity
using point-to-point wireless bridge capability using 802.11 standards. Essentially, two
access points configured in point-to-point bridge capability can connect/link the two
physical locations or buildings together through an encryption wireless connection.
Although this product supports multiple wireless modes, the basic installation will only
cover the primary application of point to point wireless connectivity in WDS (Wireless
Distribution System) Bridge Mode using AES encryption for security.
Minimum Installation Requirements
• Computer with RJ-45 Ethernet port and web browser
• 4 x RJ-45 Ethernet cables (not included)
• Phillips screwdriver (not included, for grounding wire installation only)
• Additional TRENDnet TEW-740APBO H/W: v2.XR N300 directional wireless
access point (For TEW-740APBO single unit only, TEW-740APBO2K model
includes two preconfigured access points)
For wall mounting only (included wall mounting kit for drywall installations only)
• Power drill/driver
• 7/16 in (2.75 mm) straight drill bit for hard wood or 3/32 in (2.35 mm) bit for
soft wood (for mounting screws)
• 11/16 in (4.3 mm) straight drill bit for hard wood or 5/32 in (4 mm) bit for soft
wood (if required for drywall anchors)
• Philips driver bit or screwdriver