User's Guide
Table Of Contents
- Product Overview
- Primary Product Application
- Minimum Installation Requirements
- Model Differences
- TEW-740APBO Setup & Installation
- TEW-740APBO2K Setup and Installation
- Wireless Installation Tips
- Application Modes
- Access your access point management page
- AP Management Settings
- Management Setup
- Set the device date and time
- SNMP Settings
- Backup and restore your AP configuration settings
- Reset your AP to factory defaults
- Soft reboot your AP
- Upgrade your AP firmware
- Network Utilities
- View system information
- View currently connected wireless client devices
- View currently connected authenticated users
- View authentication log information
- View the device system log information
- Configuring additional application modes
- Access Point (AP) Mode
- Set the device to AP mode
- Set the device LAN IP address
- Configure primary wireless network settings
- MAC Address Filter
- DHCP Server
- DHCP Reservation/Static Lease
- 802.11r/802.11k Fast Roaming
- Additional Wireless Settings
- Advanced Wireless Settings
- Wireless WMM QoS Setup
- WDS (Wireless Distribution System)
- Authentication/Captive Portal
- Guest Authentication
- OAuthentication 2.0
- POP3 Server
- Customize Page
- Multiple Language
- Walled Garden
- Privilege Address
- Backup/Restore Authentication Profile & Customized Pages
- Client Bridge + AP Mode
- WISP (CPE) + AP Mode
- Router Mode
- CAP (Control AP) Mode
- Access Point (AP) Mode
- Technical Specifications
- Appendix
© Copyright 2020 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-740APBO / TEW-740APBO2K
78
Group Setup
AP Control > Group Setup
This section allows you to create specific AP groups for batch configuration to be
applied.
Click AP Control and click on Map Setup. Click Create New Map. Click Save to save the
new map reference.
• Map Name –Enter a name to identify this map.
• Image URL – Enter the URL location of the image to use.
• Description – Enter a brief text description to help further provide detail about
the map.
• Image – After the correct image URL has been provided, click View to view the
map.
Map Setup
AP Control > Map Setup
This section allows you to reference online maps to help you identify AP deployment
areas and locations. Please note that you can only reference and view maps from
interface only. Map editing is not supported. You will need to create and edit your map
using another third party software.
Click AP Control and click on Map Setup. Click Create New Map. Click Save to save the
new map reference.
• Map Name –Enter a name to identify this map.
• Image URL – Enter the URL location of the image to use.
• Description – Enter a brief text description to help further provide detail about
the map.
• Image – After the correct image URL has been provided, click View to view the
map.