User Guide

© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-755AP
26
HT Physical Mode
 Guard Interval: Select to enable short guard interval (400ns).
 A-MPDU: MPDU aggregation also collects Ethernet frames to be transmitted to a
single destination, but it wraps each frame in an 802.11n MAC header. Normally
this is less efficient than MSDU aggregation, but it may be more efficient in
environments to maintain performance in noisy networks and to prevent hidden
nodes from degrading the performance.
Client Limit
 Client Limit: Select enable to turn on client limit of the select wireless band
 Max Client: Enter the amount of clients to allow
4. Click on Save/Reload button located on the top left section to apply settings.
Change your IP address
System > IP Settings
In most cases, you do not need to change the IP address settings. Typically, the IP
address settings only needs to be changed, if you plan to use another access point in
your network with the same IP address settings, if you are connecting your access point
to an existing network that is already using the IP address settings your access point is
using.
Note: If you are not encountering any issues or are not faced with one of the cases
described above or similar, it is recommended to keep your router IP address settings as
default.
Default Router IP Address: 192.168.10.100 / 255.255.255.0
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the System tab and click IP Settings.
3. Review the settings and click Apply to save changes.
 Connection Type: Select on the pull down menu the LAN connection type.
o DHCP: Select this option to have the access point obtain an IP address from your
DHCP server
o STATIC: Select this option to manually assign and IP address to your access point
 DNS Server: Enter your network’s DNS server IP address
4. Click on Save/Reload button located on the top left section to apply settings.