User Guide

© Copyright 2015 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-755AP
30
 SNMPv3: Select option to enable or disable SNMPv3
 Username: Enter the username
 Auth Protocol: Select from the pull down menu the authentication protocol to use
 Authentication Key: Enter the authentication key
 Priv Protocol: Select the private protocol
 Priv Key: Enter the private key
 Engine ID: Enter the engine name
4. Click on Save/Reload button located on the top left section to apply settings.
Enable CLI
Management > CLI Settings
To enable the Command Line Interface for batch management or advanced
configuration, select CLI ON and then click Apply.
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the Management tab and click CLI.
3. Select ON and click Apply to save settings.
4. Click on Save/Reload button located on the top left section to apply settings.
LED Controls
Management > LED Control
1. Log into your management page (see “Access the management page” on page 16).
2. Click on the Management tab and click LED Control.
3. Review the settings and click Apply to save settings.
 Power LED: Select On to leave Power LED on or Off option to turn off.
 LAN LED: Select On to leave LAN LED on or Off option to turn off.
 2.4GHz LED: Select On to leave wireless 2.4GHz LED on or Off option to turn off.
4. Click on Save/Reload button located on the top left section to apply settings.