User Guide
Table Of Contents
- Product Overview
- Configuration
- Wireless Networking and Security
- Advanced configuration
- Access Point
- Client Bridge
- WDS
- Repeater
- Basic
- Scan for wireless networks
- Advanced wireless settings
- Roaming Support (802.11k)
- RSSI Scanner
- IPv6 Settings
- Local Connection Only
- Static IPv6
- Auto Configuration (SLAAC/DHCPv6)
- Change your IP address
- Captive Portal
- Configure Spanning Tree
- Set date and time
- Daylight Saving Time
- NTP
- Manual
- Manage VLAN
- Traffic Shaping
- Enable SNMP
- Enable CLI
- LED Controls
- Maintenance & Monitoring
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-755AP
22
Wireless Mode: Select the wireless mode to set on the selected wireless band in
client bridge mode
SSID: Manually enter the wireless network name (SSID) you want to establish
connection. Or simply click on Site Survey to scan for available wireless network.
Preferred BSSID: Click option and enter the preferred wireless network you would
like to connect to.
Security Mode: Select from the pull-down menu the wireless security that is used
on the wireless network you would like to connect to.
6. Click on the Save/Reload button located on the top left section to save the settings.
Scan for wireless networks
Wireless 2.4GHz > Wireless Network
This section outlines the available features to configure when Repeater mode is
selected.
1. Log into your management page (see “Access the management page” on page 16).
2. Click on Wireless 2.4GHz and click Wireless Network.
3. Under SSID section click Site Survey to wireless scan for available wireless networks.
4. Click on the wireless network you would like to repeat. The information will
automatically fill on the previous screen. You will then need to select and enter the
wireless security.
5. Click on Apply button to apply the settings and then click on the Save/Reload button
located on the top left section to save the settings.