User's Guide
Table Of Contents
- Product Overview
- Configuration
- Wireless Networking and Security
- Advanced configuration
- Access Point
- Basic
- Wireless Profile
- Wireless MAC filter
- Airtime Fairness
- Roaming Support (802.11k)
- RSSI Scanner
- IPv6 Settings
- Static IPv6
- Auto Configuration (SLAAC/DHCPv6)
- Change your IP address
- Captive Portal
- Configure Spanning Tree
- Set date and time
- Daylight Saving Time
- NTP
- Manual
- Manage VLAN
- Traffic Shaping
- Enable SNMP
- Enable CLI
- LED Controls
- Client Bridge
- WDS
- Repeater
- Maintenance & Monitoring
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-755AP
32
Scan for wireless networks
Wireless 2.4GHz > Wireless Network
This section outlines the available features to configure when Client Bridge mode is
selected.
1. Log into your management page (see “Access the management page” on page 13.
2. Click on Wireless 2.4GHz.
3. Under SSID section click Scan to wireless scan for available wireless networks.
4. Click on the wireless network you would like to connect. The information will
automatically fill on the previous screen. You will then need to select and enter the
wireless security.
5. Click on Apply button to apply the settings and then click on the Save/Reload button
located on the top left section to save the settings.
WDS
WDS Link
Wireless 2.4GHz > WDS Link Settings
This section outlines the available features to configure when WDS mode is selected.
1. Log into your management page (see “Access the management page” on page 13.
2. Click on System, and select Operation Mode.
3. Enable WDS Access Point,