User's Guide
Table Of Contents
- Product Overview
- Configuration
- Wireless Networking and Security
- Advanced configuration
- Access Point
- Basic
- Wireless Profile
- Wireless MAC filter
- Airtime Fairness
- Roaming Support (802.11k)
- RSSI Scanner
- IPv6 Settings
- Static IPv6
- Auto Configuration (SLAAC/DHCPv6)
- Change your IP address
- Captive Portal
- Configure Spanning Tree
- Set date and time
- Daylight Saving Time
- NTP
- Manual
- Manage VLAN
- Traffic Shaping
- Enable SNMP
- Enable CLI
- LED Controls
- Client Bridge
- WDS
- Repeater
- Maintenance & Monitoring
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-755AP
33
4. Click on Wireless 2.4GHz.
5. Configure the below settings and click Apply to save settings.
Site Survey: Click this option to scan for available WDS networks
Remote AP MAC: Enter the MAC address of the remote access point you want to
establish WDS connection.
Security Mode: Select from the pull-down menu the wireless security that is used
on the wireless network you would like to connect to.
6. Click on Apply button to apply the settings and then click on the Save/Reload button
located on the top left section to save the settings.