User's Guide
Table Of Contents
- Product Overview
- Configuration
- Wireless Networking and Security
- Advanced configuration
- Access Point
- Basic
- Wireless Profile
- Wireless MAC filter
- Airtime Fairness
- Roaming Support (802.11k)
- RSSI Scanner
- IPv6 Settings
- Static IPv6
- Auto Configuration (SLAAC/DHCPv6)
- Change your IP address
- Captive Portal
- Configure Spanning Tree
- Set date and time
- Daylight Saving Time
- NTP
- Manual
- Manage VLAN
- Traffic Shaping
- Enable SNMP
- Enable CLI
- LED Controls
- Client Bridge
- WDS
- Repeater
- Maintenance & Monitoring
- AP utility
- Technical Specifications
- Troubleshooting
- Appendix
© Copyright 2017 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-755AP
34
Basic
Wireless 2.4GHz > Wireless Network
This section outlines the available features to configure when Access Point mode is
selected.
1. Log into your management page (see “Access the management page” on page 13.
2. Click on System, and select Operation Mode.
3. Enable WDS Access Point.
4. Click on Wireless 2.4GHz.
3. Configure the below settings and click Apply to save settings.
Wireless Mode: If all of the wireless devices you want to connect with this Access
Point can connect in the same transmission mode, you can improve performance
slightly by choosing the appropriate mode. If you have some devices that use a
different transmission mode, choose the appropriate mode.
2.4GHz Wireless
o B/G/N mixed: Select this mode for the best compatibility. This mode allows older
802.11b and 802.11g wireless devices to connect to the access point in addition
to newer 802.11n devices.
o B/G mixed: This mode only allows devices to connect to the access point using
older and slow 802.11b or 802.11g technology and it thereby reduces the access
point’s maximum speed to 54Mbps (typically not recommended).
o N only: This mode only allows newer 802.11n devices to connect to your access
point. This mode does ensure the highest speed and security for your network,
however if you have older 802.11g wireless clients, they will no longer be able to
connect to this access point.
o G only: This mode only allows devices to connect to the access point using older
and slow 802.11g technology (typically not recommended).
o B only: This mode only allows devices to connect to the access point using older
and slow 802.11b technology (typically not recommended).
Note: Please check the specifications on your wireless devices for the highest
wireless capability supported first before applying these settings. If you are
unsure, it is recommended that you keep the default setting (B/G/N mixed) for the
best compatibility.
Channel Width: Extension channel: When 20/40 channel bandwidth has been
chosen, you should select extension channel to get higher throughput.
Frequency (Channel): In North America, this access point can broadcast on 1 of 11
Channels for 2.4GHz (13 in Europe and other countries). Selecting the Auto option
enables the access point to automatically select the best Channel for wireless
communication. To manually set the channel on which the access point will
broadcast, click the drop-down list and select the desired Channel for wireless
communication. The goal is to select the Channel that is least used by neighboring
wireless networks.
4. Click on Save/Reload button located on the top left section to apply settings.
Wireless Profile
Wireless 2.4GHz > Wireless Network
This section outlines the available features to configure when Access Point mode is
selected.
1. Log into your management page (see “Access the management page” on page 13.
2. Click on Wireless 2.4GHz and click Wireless Network.