User's Guide
Table Of Contents
- Product Overview
- Router Setup
- Basic Router Settings
- Qualcomm® StreamBoost™
- Wireless Networking and Security
- Advanced Router Settings
- Change your router login password
- Manually configure your Internet connection
- IPv6 Settings
- Clone a MAC address
- Change your router IP address
- Set up the DHCP server on your router
- Set up DHCP reservation
- Enable/disable UPnP on your router
- Enable/disable Application Layer Gateways (ALG)
- Allow/deny multicast streaming
- Identify your network on the Internet
- Set your router date and time
- Create schedules
- Access Control (IP Protocol Filter)
- Inbound Filter
- Open a device on your network to the Internet
- Virtual Server
- Allow remote access to your router management page
- Using External USB Storage
- Virtual Private Networking (VPN)
- Router Maintenance & Monitoring
- Reset your router to factory defaults
- Router Default Settings
- Backup and restore your router configuration settings
- Reboot your router
- Upgrade your router firmware
- Allow/deny ping requests to your router from the Internet
- How to capture network packets
- Diagnostic Tools
- Wireless Client List
- Check the router system information
- View your router log
- Router Management Page Structure
- Technical Specifications
- Appendix
© Copyright 2016 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-827DRU
68
Diagnostic Tools
Advanced > Administrator > Diagnostics
The router also provides additional tools for network troubleshooting such as ping test,
traceroute, nslookup, and netstat.
Wireless Client List
Advanced > Wireless (2.4GHz or 5GHz) > Station List
You can view the list of active wireless devices currently connected to your router.
1. Log into your router management page (see “Access your router management page”
on page 10).
2. Click on Advanced and click on Wireless (2.4GHz or 5GHz), then click on Station List
MAC Address: The current MAC address of your 2.4GHz wireless client.
Mode: Displays the 802.11 mode associated with the client.
Rate: Displays the estimated data rate established with the client.
Signal: Displays the estimated signal strength associated with the client.
.