Quick Installation Guide Indoor / Outdoor Antenna, Antenna Cable & Surge Arrestor
Table of Contents English ........................................................................................................................... 1 1. Outdoor Antenna Installation ............................................................................... 1 2. How to install the surge arrestor ........................................................................ 4 3. Weatherproof tape for outdoor installations ....................................................... 5 4.
1. Outdoor Antenna Installation Before installation, please ensure you have the required products and that the contents of each product are complete.
1. Disconnect the default dipole antenna from your indoor access point or router. 2. Attach the blue sleeve (Reverse SMA) of the jumper cable to your Wi-Fi Device. 3. Connect the black sleeve (N-Type) of the jumper cable to the surge arrestor.
4. Connect remaining surge arrestor connector to the blue sleeve (N-Type) of the antenna cable (TEW-L406/ TEW-L412) 5. Connect the Green wire to grounding object. e.g. 1. Earth Driven rod 2. Grounded Electrical System 3. Building frame 6. Connect the remaining black sleeve (N-Type) of the Antenna Cable to the Antenna. 7. Your Outdoor Antenna installation is now complete.
2. How to install the surge arrestor 1. Before installing the antenna, make sure the low loss outdoor cable (TEW-L406/TEW-L412) can reach the location of access point or router. Attach the enclosed cable adapter’s blue sleeve to the Wi-Fi device (Reverse SMA) and the cable adapters black sleeve (N-type) to the surge arrestor. 2. Take out the L-type metal bracket and mark the mount position on the wall. 3. Screw it to the wall. 4. Seat the arrestor into bracket. Put on the washer. Screw on the nut.
3. Weatherproof tape for outdoor installations If your surge arrestor is installed outdoors, remember to wrap both connectors tightly with the enclosed weatherproofing tape.
4. Indoor Antenna Installation Before installation, please ensure you have the required products and that the contents of each product are complete. TEW-L202/TEW-L208 TEW-L202 – cable (2 meter) TEW-L208 – cable (8 Meter) One of the following Antennas: TEW-AO08O TEW-AO10O TEW-AO09D TEW-AO14D TEW-AO19D Note: The following Indoor Antennas come with cables or connect directly to your Wi-Fi Device.
1. Disconnect the dipole antenna from your access point or router. 2. Attach the blue sleeve (Reverse SMA) of the indoor cable (TEW-L202/ TEW-L208) directly to the Wi-Fi Device. 3. Connect the remaining black sleeve (N-Type) of the antenna cable to the blue sleeve of the (N-type) antenna. 4. Your Indoor Antenna installation is now complete.
Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase.
WARRANTIES EXCLUSIVE: IF THE TRENDnet PRODUCT DOES NOT OPERATE AS WARRANTED ABOVE, THE CUSTOMER'S SOLE REMEDY SHALL BE, AT TRENDnet'S OPTION, REPAIR OR REPLACEMENT. THE FOREGOING WARRANTIES AND REMEDIES ARE EXCLUSIVE AND ARE IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED OR IMPLIED, EITHER IN FACT OR BY OPERATION OF LAW, STATUTORY OR OTHERWISE, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
TRENDnet Technical Support Product Warranty Registration Please take a moment to register your product online. Go to TRENDnet’s website at http://www.trendnet.com 3135 Kashiwa Street Torrance, CA 90505 USA Copyright ©2006. All Rights Reserved. TRENDnet.
