User's Manual

CONFIGURING THE WIRELESS LAN ACCESS POINT

The Wireless Access Point has a Web GUI interface for the configuration. The AP

can be configured through the Web Browser. A network manager can manage,

control and monitor the AP from the local LAN. This section indicates how to

configure the AP to enable its functions.

Before configuring the Wireless AP through WLAN, make sure that the SSID,

Channel and the WEP was set properly.

The default setting of the Wireless AP that you will use:

SSID: default

Channel: 6

WEP Encryption: disable

Before you configure this device, note that when the AP is configured through an

Ethernet connection, make sure the manager PC must be set on same the IP

network. For example, when the default network address of the default IP address

of the AP is 192.168.1.100, then the manager PC should be set at 192.168.1.x

(where x is a number between 1 and 254), and the default subnet mask is

255.255.255.0.

Open Internet Explorer 5.0 or above Web browser.

Enter IP address http://192.168.1.100 (the factory-default IP address setting) to the

address location.