User's Manual

3
HARDWARE INSTALATION
LED Indicator
The figure below shows the LED Indicator of the Wireless LAN Access Point.
PWR/Power
This indicator lights green when the Access Point receives power. Otherwise, it
turns off.
LAN (Link/ACT)
The indicator lights green when the LAN port is connected to a 100Mbps Ethernet
station, the indicator blinks green while transmitting or receiving data on the
100Mbps Ethernet network.
WLAN (Link)
The indicator always blinks green while the wireless AP is always broadcasting
packets.
Rear Panel
The figure below shows the rear panel of the Access Point
- +
E thernet Re set
Antenna 1 Antenna 2
Dual Antenna
Model
DC IN
Et herne t
Reset
- +
Single Antenna
Model
Rear Panel
Ethernet
Ethernet uplink port with 10/100Mbps Fast Ethernet connections, connect this port
to switch/hub.
Reset
The Reset function is to reset the setting back to factory default setting, once you
press the “RESET” button within 10 seconds, the LED of the WLAN will turn off.
And when the Access Point is ready, the WLAN LED will start blinking.
And the other function is when the AP is locked, press the reset button to unlock it.
DC Power
Connect the Power Adapter DC plug to the AP’s power jack.