User's Manual Part 1

ManualsBrandsTRENDNET ManualsComputers & Accessories150Mbps Micro Wireless N USB Adapter

Summary of content (6 pages)

PAGE 1
PAGE 2
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
Industry Canada statement: This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
PAGE 4
Česky [Czech] TRENDnet tímto prohlašuje, že tento TEW-648UBM je ve shodě se základními požadavky a dalšími příslušnými ustanoveními směrnice 1999/5/ES. Dansk [Danish] Undertegnede TRENDnet erklærer herved, at følgende udstyr TEW648UBM overholder de væsentlige krav og øvrige relevante krav i direktiv 1999/5/EF.
PAGE 5
Slovensko [Slovenian] TRENDnet izjavlja, da je ta TEW-648UBM v skladu z bistvenimi zahtevami in ostalimi relevantnimi določili direktive 1999/5/ES. Slovensky [Slovak] TRENDnet týmto vyhlasuje, že TEW-648UBM spĺňa základné požiadavky a všetky príslušné ustanovenia Smernice 1999/5/ES. Suomi [Finnish] TRENDnet vakuuttaa täten että TEW-648UBM tyyppinen laite on direktiivin 1999/5/EY oleellisten vaatimusten ja sitä koskevien direktiivin muiden ehtojen mukainen.
PAGE 6
TABLE OF CONTENT Introduction ................................................................................................ 6 Unpacking and Setup .................................................................................. 7 Unpacking ............................................................................................................... 7 System Requirements ............................................................................................. 7 IDentifying external components .....