User's Manual Part 1

i
Federal Communicaon Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal
installaon. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instrucons, may cause harmful interference to radio communicaons. However, there is no
guarantee that interf
erence will not occur in a parcular installaon. If this equipment does cause harmful interference
to radio or television recepon, which can be determined by turning the equipment o and on, the user is encouraged
to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separaon between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is conne
cted.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Cauon: Any changes or modicaons not expressly approved by the party responsible for compliance could void
the user's authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operaon is subject to the following two condions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operaon.
IM
PORTANT NOTE:
Radiaon Exposure Statement:
The product comply with the US/Canada portable RF exposure limit set forth for an uncontrolled environment and are safe
for intended operaon as described in this manual. The further RF exposure reducon can be achieved if the product can
be kept as far as possible from the user body or reduce output power if it doesn't affect the transmission/receiving quality.
This transmier must not be co-located or operang in conjuncon with any other antenna or transmier.
SAR compliance has been established in typical laptop computer(s) with USB slot, and product could be used in typical
laptop computer with USB slot. Other applicaon like handheld PC or similar device has not been veried and may not
compliance with related RF exposure rule and such use shall be prohibited.
The availability of some specific channels and/or operaonal frequency bands
are country dependent and are rmware
programmed at the factory to match the intended desnaon. The firmware seng is not accessible by the end user.
For Taiwan
語:
經型式認證合格之低功率射頻電機,非經許可,公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計
特性及功能。
低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並改善至無干擾時
得繼續使用。前項合法通信,指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及
療用電波輻射性電機設備之干擾。