User Manual

© Copyright 2012 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TEW-652BRU
36
1. Log into your router management page (see “Access your router management page”
on page 26).
2. Click on Access, and click on Special AP.
To simplify configuration, there is a list of commonly used pre-defined special
application entries to modify, otherwise, you can choose to manually add a new special
application.
3. Review the special application settings.
• Enabled – Selecting Enabled turns on the special application and selecting
Disabled turns it off.
• Name – Enter a name for the special application.
• Trigger – Port or port range requested by the device.
o Protocol – Select the protocol requested by the device. TCP, UDP, or you
can select Both to choose both TCP and UDP.
o Port Range – Enter the ports or port range requested by the device.
(e.g. 554-554 or 6112-6112).
Note: Please refer to the device documentation to determine which ports and protocols
are required.
• Incoming – Port(s) forwarded to the device.
o Protocol – Select the protocol to be forwarded to the device. TCP,
UDP, or you can select Both to choose both TCP and UDP.
o Port Range – Enter the ports or port range to be forwarded to the
device.
(e.g. 2000-2038,2069,2081,2200-2210).
Note: Please refer to the device documentation to determine which ports and
protocols are required.
• Add – Saves a new special application.
•
To modify an existing application, click on the entry in the special applications list. When
selected, the entry will be highlighted.
• Delete – Removes an existing special application.
• Update – Modifies an existing special application.
• Cancel – Discard changes to an existing special application.