User Manual

TRENDnet User’s Guide

TEW-652BRU

USB Storage and Printer Sharing

The USB Control Center Utility is used to connect your computer to USB devices that are

connected to your network through your router. The software utility allows you to use

USB devices over your network as if they were connected directly to your computer.

Note: The USB Control Center Utility is required to be installed on every computer that

will be accessing the USB devices connected to your network. The utility will only allow

one computer to connect to a USB device at any given time.

Two computers cannot connect to the same USB device at the same time, one computer

must disconnect from the USB device using the utility in order to make it available for

another computer to connect to it.

USB Port Software Utility Requirements

Supported Operating Systems CPU Memory

Windows 7 (32/64-bit) 1GHz or above 1GB RAM or above

Windows Vista (32/64-bit) 800MHz or above 512MB RAM or above

Windows XP (32/64-bit) 300MHz or above 256MB RAM or above

Mac OS X (10.7) 1.8GHz or above 2GB RAM or above

Mac OS X (10.6) 1.06GHz or above 1GB RAM or above

Mac OS X (10.5) 867MHz or above 512MB RAM or above

Mac OS X (10.4) 333MHz or above 256MB RAM or above

Software Installation

Windows OS

1. Insert the included CD-ROM into your computer’s CD-ROM drive.

2. At the CD Autorun Prompt window, click Run Autorun.exe

Note: If the Autorun prompt does not appear automatically, open the CD contents and

double-click Autorun.exe.

3. At the CD-ROM menu window, click Install Utility.