TEW-735AP User’s Guide © Copyright 2013 TRENDnet. All rights reserved.
TEW-735AP User’s Guide Table of Contents Table of Contents Product Overview �������������������������������������������������������������������������������1 Log-in System Management for the First Time ��������������������������������� 7 Package Contents ������������������������������������������������������������������������������ 1 Setup Wizard ������������������������������������������������������������������������������������� 9 Features �������������������������������������������������������������
TEW-735AP User’s Guide Product Overview Product Overview Features TRENDnet’s plenum rated business class N300 High Power PoE Access Point, model TEW-735AP, greatly increases wireless coverage as compared to standard access points. A variety of installation scenarios are supported with Access Point, WDS AP, WDS Bridge, and Repeater modes. Save installation time and costs with PoE.
TEW-735AP User’s Guide Product Overview Front Panel Mounting Holes Reset Button Mounting holes Kensington security slot Wireless Network Power Reset Button • • Power LED OFF Powered off or LED display has been disabled ON Powered on OFF No network connected through Ethernet port (PoE) or LED display has been disabled ON Network connected through Ethernet port (PoE) Flashing Network activities are detected on Ethernet (PoE) port OFF No wireless network connection or LED display has been
TEW-735AP User’s Guide Product Overview Product Pre-set Information Mounting Accessories There are 2 product pre-set labels comes with the package. The first label is located on top of plastic wrap of TEW-735AP. The second label is on the bottom of TEW-735AP. You can find default SSID, wireless key, administrator account, and administrator password. The default static management IP has set to 192.168.10.100.
TEW-735AP User’s Guide Installation Hardware Installation Mount on Wall or Ceiling Use two P3.5 pan head screws to hold the TEW-735AP. The distance between mounting points is 2 3/4” (7cm) © Copyright 2013 TRENDnet. All rights reserved. Mount on T-Bar Two additional bronze screw holes are provided for T-Bar mounting. Use two P2.6 screws to secure the TEW-735AP on T-Bar clip and then clip on the T-Bar.
TEW-735AP User’s Guide Wireless Performance Considerations There are a number of factors that can impact the range of wireless devices. Adjust your wireless devices so that the signal is traveling in a straight path, rather than at an angle. The more material the signal has to pass through the more signal you will lose. Keep the number of obstructions to a minimum. Each obstruction can reduce the range of a wireless device.
TEW-735AP User’s Guide Installation Application Diagram WDS WDS AP Access Point Repeater Multiple SSID SSID/STA isolation © Copyright 2013 TRENDnet. All rights reserved.
TEW-735AP User’s Guide System Configuration System configuration System Management and Default Settings If you have a brand new TEW-735AP or if you just reset TEW-735AP to factory default by press and holding reset button for over 10 seconds, your TEW-735AP has following settings: Management IP : Administrator name : Administrator password : Default SSID : Default SSID passphrase : 2 Searching wireless connection with your computer network settings. The default SSID is showed on device label.
TEW-735AP User’s Guide 3 Open a web browser and type http://tew-735ap to access administration page. If you setup with a static IP on your PC, please open a web browser and type http://192.168.10.100 The TEW-735AP login page will show up. System Configuration 4 Change your administration login password away from factory default setting. Click Apply to continue. 5 TEW-735AP will apply password change and then reboot. Login again with your new password.
TEW-735AP User’s Guide System Configuration Setup Wizard Setup wizard is provided as part of the web configuration utility. It sets up the basic administrator password and management IP address by clicking on the Wizard button on the function menu. The following screen will appear. Enter your new administrator password and then click Next to continue. Enter the management IP address for this TEW-735AP. The default IP address is 192.168.10.100.
TEW-735AP User’s Guide System Configuration Status Main status page shows TEW-735AP basic information. WLAN Settings Channel : Wireless channel SSID_1 - 4 : Service Set Identifier. This SSID is human readable and performs as ESSID to setup wireless groups. You can set up to 4 SSID on a single TEW735AP. Security : Shows what security encryption is using for this wireless connection BSSID : Basic SSID. This is strictly unique SSID to identify this wireless access point (WAP).
TEW-735AP User’s Guide IPv6 This page shows TEW-735AP IPv6 link local address. You can manage TEW-735AP using this IPv6 link local address if your computer is IPv6 enabled and in the same broadcast domain. Put a bracket around your IPv6 address to visit the management site. (i.e. http://[IPv6 address]) System Configuration Wireless Client List This page shows all wireless clients connected to this TEW-735AP.
TEW-735AP User’s Guide System Log This page allows users to view a running log of the access point system statistics, events and activities. System Configuration Multiple Language You can choose the language you preferred on login page. Or, you can change your language setting here. Save : Click this button to save the log to your computer Clear : Click this button to clear up the log Refresh : Click this button to refresh the log © Copyright 2013 TRENDnet. All rights reserved.
TEW-735AP User’s Guide System Configuration System Operation Mode You can choose one of the mode to fit your network plan: Access Point, WDS AP, WDS Bridge and Universal Repeater. WDS Bridge In this operation mode. TEW-735AP connects ONLY to other WDS (Wireless Distribution System) as a backbone bridge. Universal Repeater TEW-735AP repeats wireless signal and packets in this mode for backbone communication as well as client access.
TEW-735AP User’s Guide IP Settings The TEW-735AP has a static IP 192.168.10.100 set in factory for management purpose. You can change this IP address to fit your network plan or manage multiple TEW-735AP. You can also set TEW735AP to DHCP client accepting IP dynamically. System Configuration Bridge Type : Select Static IP or Dynamic IP from the drop-down list. If you select Static IP, you will be required to specify an IP address and subnet mask.
TEW-735AP User’s Guide System Configuration Spanning Tree TEW-735AP is designed for terminal access as well as backbone connection. To avoid network looping, you can enable 802.1d spanning tree protocol. Spanning Tree Status: Enable or disable 802.1d spanning tree protocol to avoid network looping Bridge Hello Time : The time between each bridge protocol data unit (BPDU). Default: 2 sec. Bridge Max Age : Maximum time a BPDU kept in bridge. Default: 20 sec.
TEW-735AP User’s Guide System Configuration Wireless Basic General setups for your wireless connection. You can setup up to four SSIDs for different group of users.
TEW-735AP User’s Guide Security Set up wireless security settings in this page. Select SSID you want to set up, change the value and then click on Apply to commit the changes. Enabling security prevents any unauthorized wireless clients to connect into your network. ESSID Selection : Select the SSID you want to set up wireless security Separate : SSID: If you check this box, clients associated with this SSID cannot communicate with wireless clients associated with other SSID directly.
TEW-735AP User’s Guide Encryption (WEP) : WEP, Wire Equivalent Protection, provides a basic wireless security Authentication Type : Select Open System, Shared Key, or auto. Open System allows any client to authenticate as long as it conforms to any MAC address filter policies that may have been set. All authentication packets are transmitted without encryption. Shared Key sends an unencrypted challenge text string to any device attempting to communicate with the AP.
TEW-735AP User’s Guide Encryption Wi-Fi Protected Access (WPA) pre-shared (WPA pre-shared key) : key WPA Type : Select TKIP, AES, or WPA2 Mixed. The encryption algorithm used to secure the data communication. TKIP (Temporal Key Integrity Protocol) provides per-packet key generation and is based on WEP. AES (Advanced Encryption Standard) is a very secure block based encryption.
TEW-735AP User’s Guide Advanced Fine tuning your wireless settings on this page. Fragment Threshold : Packets over the specified size will be fragmented in order to improve performance on noisy networks. Specify a value between 256 and 2346. The default value is 2346. RTS Threshold : Packets over the specified size will use the RTS/CTS mechanism to maintain performance in noisy networks and preventing hidden nodes from degrading the performance. Specify a value between 0 and 2347.
TEW-735AP User’s Guide CTS Protection : Clear to Send, CTS, can be always enabled, auto, or disabled. By enabled CTS, the Access Point and clients will wait for a ‘channel cleared’ signal before transmitting. It is recommended setting to auto. Tx Power : Wireless signal transmission power. Set transmission power to appropriate value can make your multiple AP deployment easier. The default value is 26 dBm. Valid settings are between 11 and 29.
TEW-735AP User’s Guide Encryption : MAC address: Enter the device’s MAC address ADD: Click to add MAC address into table Reset: Click to reset entry Delete Selected: Allows you to delete selected entry Delete All: Deletes all entries in the MAC address table Reset: Reset all entries Apply: Click to apply changes made Cancel: Click to cancel any new setting changes made.
TEW-735AP User’s Guide WPS WPS is the simplest way to connect a wireless client to TEW-735AP. You don’t have to select the encryption mode and fill in a long encryption passphrase every time when you try to setup a wireless connection. You only need to press a button on both wireless client and TEW-735AP, and the WPS will do the rest for you. The TEW-735AP supports two types of WPS: WPS via Push Button and WPS via PIN code.
TEW-735AP User’s Guide System Configuration Management Administration Change the password required to log into the access point’s web-based management. Passwords can contain 0 to 12 alphanumeric characters, and are case sensitive. Enter your password and system information and then click Apply to save the change. System Name: The system name can be identified on your local network. Changing this system name can change the way you access this AP.
TEW-735AP User’s Guide Management VLAN This feature is only available under Access Point or WDS AP mode and allows users to configure the 802.1q VLAN settings to for all wireless clients. Enter VLAN ID you want to tag to clients associated with specific SSID. Different SSID should set to different VLAN ID. Enable Virtual LAN service and click Apply to save the changes. LAN VLAN MGMT is a special VLAN to manage TEW-735AP.
TEW-735AP User’s Guide SNMP Setting SNMP Setting allows you to assign the contact details, location, community name and trap settings for SNMP. This is a networking management protocol used to monitor network-attached devices. SNMP allows messages (called protocol data units) to be sent to various parts of a network. Upon receiving these messages, SNMP-compatible devices (called agents) return data stored in their Management Information Bases.
TEW-735AP User’s Guide Backup / Restore Settings This page allows you to save the current configurations. Click Save to save your current configuration. System Configuration Auto Reboot Settings Click on Apply, the TEW-735AP will going through all the reboot process automatically. To load configurations saved previously, click Browse ... to find configuration file and then click Upload. In case you want to reset TEW-735AP configuration back to factory default, click Reset in this page.
TEW-735AP User’s Guide Firmware Upgrade TRENDnet may periodically release firmware upgrades that might add features or fix problems associated with your TRENDnet model and version. To find out if there is a firmware upgrade available for your device, please check your TRENDnet model and version using the link.
TEW-735AP User’s Guide Apply : Click this button to apply the change Cancel : Click this button to abandon the change System Configuration Schedule Service schedule can be set up daily or weekly for power saving and security reason. Click Add to add a schedule rule entry. Select an entry and click Edit or Delete Selected to change the entry. Click Delete All to remove all entries. After schedule editing, click Apply to save your schedule. Check Enabled Schedule Table to make AP services work with schedule.
TEW-735AP User’s Guide Diagnosis To check your network connection, you can use the PING tool from your TEW-735AP. Enter the IPv4 address you want to ping and click Start. The result will be showed in the terminal down below. © Copyright 2013 TRENDnet. All rights reserved. System Configuration LED Control All LED indicators are turned on by default. You can turn any one of them or all of them on or off. Click the LED you want to change the action and then click Apply to save the changes.
TEW-735AP User’s Guide System Configuration Logout Logout from the management page. The TEW-735AP allows only one management login at the same time. If you want to access the TEW-735AP from different computer, remember to logout the web management page first. © Copyright 2013 TRENDnet. All rights reserved.
TEW-735AP User’s Guide FCC Interference Statement Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
TEW-735AP User’s Guide Europe – EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/EC, 2006/95/EC and 2009/125/EC..
TEW-735AP User’s Guide cs Česky [Czech] da Dansk [Danish] de Deutsch [German] et Eesti [Estonian] en English es Español [Spanish] Ελληνική [Greek] el Français [French] fr it Italiano [Italian] Latviski [Latvian] lv Lietuvių [Lithuanian] lt TRENDnet tímto prohlašuje, že tento TEW-735AP je ve shodě se základními požadavky a dalšími příslušnými ustanoveními směrnice 1999/5/ES, 2006/95/ES, a 2009/125/ES.
TEW-735AP User’s Guide Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service, for the following lengths of time from the date of purchase. • • TEW-735AP – 3 Years Warranty AC/DC Power Adapter, Cooling Fan, and Power Supply carry 1 year warranty.
TEW-735AP User’s Guide © Copyright 2013 TRENDnet. All rights reserved.
