User's Manual

TEW-753DAP User’s Guide System Conguration
© Copyright 2013 TRENDnet. All rights reserved.
28
N Data Rate : Select dierent 802.11N Modulaon and
Coding Scheme (MCS) against parcular
wireless noise. Or, select auto leng
TEW-753DAP select MCSs dynamically.
Channel Bandwidth : Select channel bandwidth for
1) Dynamic select 20 MHz and 40MHz
bandwidth or 2) choose 20MHz channels
only�
Preamble Type : Select a short or long preamble. For
opmum performance it is recommended
to also congure the client device to the
same preamble type.
CTS Protecon : Clear to Send, CTS, can be always
enabled, auto, or disabled. By enabled
CTS, the Access Point and clients will
wait for a ‘channel cleared’ signal before
transming. It is recommended seng to
auto�
Tx Power : Wireless signal transmission power. Set
transmission power to appropriate value
can make your mulple AP deployment
easier. The default value is 26 dBm. Valid
sengs are between 11 and 29.
Apply :
Click this buon to apply the change
Cancel :
Click this buon to abandon the change
Apply :
Click this buon to apply the change
Cancel :
Click this buon to abandon the change
WPS
WPS is the simplest way to connect a wireless client to TEW-753DAP.
You don’t have to select the encrypon mode and ll in a long
encrypon passphrase every me when you try to setup a wireless
connecon. You only need to press a buon on both wireless client and
TEW-753DAP, and the WPS will do the rest for you.
The TEW-753DAP supports two types of WPS: WPS via Push Buon and
WPS via PIN code. If you want to use the Push Buon, you have to push
a specic buon on the wireless client or in the ulity of the wireless
client to start the WPS pairing, and click the Start to Process buon in
this page under WPS via Push Buon to start WPS pairing.
If you want to use the PIN code, you have to know the PIN code of the
wireless client and switch it to WPS mode, then ll-in the PIN code
of the wireless client through the web conguraon interface of the
wireless router.