User's Manual

TEW-753DAP User’s Guide System Conguration

CTS Protecon : Clear to Send, CTS, can be always

enabled, auto, or disabled. By enabled

CTS, the Access Point and clients will

wait for a ‘channel cleared’ signal before

transming. It is recommended seng to

auto�

Tx Power : Wireless signal transmission power. Set

transmission power to appropriate value

can make your mulple AP deployment

easier. The default value is 26 dBm. Valid

sengs are between 11 and 29.

Apply :

Click this buon to apply the change

Cancel :

Click this buon to abandon the change

WPS

WPS is the simplest way to connect a wireless client to TEW-753DAP.

You don’t have to select the encrypon mode and ll in a long

encrypon passphrase every me when you try to setup a wireless

connecon. You only need to press a buon on both wireless client and

TEW-753DAP, and the WPS will do the rest for you.

The TEW-753DAP supports two types of WPS: WPS via Push Buon and

WPS via PIN code. If you want to use the Push Buon, you have to push

a specic buon on the wireless client or in the ulity of the wireless

client to start the WPS pairing, and click the Start to Process buon in

this page under WPS via Push Buon to start WPS pairing.

If you want to use the PIN code, you have to know the PIN code of the

wireless client and switch it to WPS mode, then ll-in the PIN code

of the wireless client through the web conguraon interface of the

wireless router.

WPS :

Check this box to enable feature

WPS Current Status : Displays the current status of the WPS

conguraon

Self Pin Code : Displays PIN code of TEW-753DAP

SSID : Displays the SSID for WPS pairing. Only

the rst SSID (SSID_1) can proceed

WPS pairing.

Authencaon

Mode :

Displays the authencaon mode of

SSID_1

Passphrase Key : Current passphrase