User's Manual

Table Of Contents

TRENDnet User’s Guide

TEW-807ECH

Connect to your wireless network using WPS

WPS (Wi-Fi Protected Setup) is a feature that makes it easy to connect devices to your

wireless network. If your wireless router/access point supports WPS, you can use this

feature to easily connect wireless devices to your network.

Note: You can typically find out if you if your wireless router/access point supports WPS

just by looking at the physical device. There should be a WPS push button located on the

exterior casing of the device, if not, your device may not support WPS or you may need

to reference your device documentation as to how WPS can be initiated on the device. If

your device does not have an identifiable WPS push button on the exterior location, we

would recommend using the standard connection method on the previous page.

There are two methods the WPS feature can easily connect your wireless devices to

your network.

• Push Button Configuration (PBC) method (Recommended)

• PIN (Personal Identification Number) Method

Virtual Push Button (PBC) Method

1. Open up the wireless utility.

2. Click on the WPS tab.

3. In the WPS window, the Push Button Configuration (PBC) option will be selected by

default. If not, check the Push Button option.

4. Click Next.

5. On your wireless router/access point, push the WPS button.

Note: Typically, the WPS button hold time is 3-5 sec., then release. For TRENDnet

routers/access points, the WPS hardware push button hold time is 3 seconds. If you are

using another brand device, you may need to refer to your device documentation for

WPS operation.

6. On the wireless utility, click Start.

7. Messages will appear utility indicating that the WPS process has been activated and

the status. Wait for the process to complete.

8. If successful, you will see the following message at the top and the connection

information at the bottom of the utility will appear. Click Finish.