Quick Installation Guide TI-F10SC/TI-F10S30
Table of Content English 1. Before You Start 2. Quick Reference 3. Hardware Installation 4.
1. Before You Start Package Contents Ÿ TI-F10SC/TI-F10S30 Ÿ Quick Installation Guide Ÿ Removable terminal block Ÿ DIN-Rail mount Ÿ Wall mount plates Minimum Requirements Ÿ Existing network Ÿ Power Supply (TI-M6024) 2.
3. Hardware Installation The fiber converter can be placed on a desktop, wall, or mounted to a DIN-Rail. DIN-rail Mounting Instructions 1. Attach the DIN-Rail mount to the fiber converter. 2. Position the unit in front of the DIN-Rail and hook the mount bracket over the top of the rail. 3. Rotate the fiber converter downward towards the rail to lock it into place. You will know it is secure when you hear the click. Mounting the unit Releasing the unit 4.
Wall Mounting Instructions 1. Attach the wall mount plates to the fiber converter. 2. Mount the unit. Safety Note ! Ÿ Turn off the power before connecting any module or wire. The correct power supply voltage (12 - 60 V DC or 18 - 36 V AC) is listed on the product label. Check the voltage of your power source to make sure that you are using the correct part. Do NOT use voltage greater than 12 - 60 V DC or 18 - 36 V AC, the product label.
Applying Power 1. Connect the power supply (sold separately) to the included terminal block (as shown below) and secure with the screws. Note: Polarities must match. 2. Attach the terminal block to the unit, connect the neutral wire to the ground, and supply power to the power adapter. 3. Connect a network source and devices to the switch. Check the LEDs to confirm the connections are established. Your installation is completed.
4. Additional information DIP Switch ON OFF 1 2 Dip 1 Dip 2 ON Converter mode OFF Switch mode (default) ON LFP function enabled OFF LFP function disabled (default) Note: LFP stands for Link Fault Pass Through. If the transmitting media converter experiences TP link loss, it will disconnect transmission. The receiving fiber converter will also disconnect.
Manufacturer’s Name and Address TRENDnet, Inc. 20675 Manhattan Place Torrance, CA 90501 USA Product Information: Model Number: TI-F10SC / TI-F10S30 Product Name: Hardened Industrial 100Base-FX Multi-Mode SC Fiber Converter (2 km, 1.2 mi.) Hardened Industrial 100Base-FX Single-Mode SC Fiber Converter (30 km, 18.6 mi.) Trade Name: TRENDnet TRENDnet hereby declare that the product is in compliance with the essential requirements and other relevant provisions under our sole responsibility.
Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service. Specific warranty periods are listed on each of the respective product pages on the TRENDnet website. Garantie Limitée TRENDnet garantit ses produits contre les problèmes de matériel ou de fabrication, dans des conditions normales d'utilisation et de service. Les périodes de garanties précises sont mentionnées sur chacun des pages produits du site web de TRENDnet.
Certifications This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical an electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or Retailer for recycling advice.
