Quick Installation Guide TI-IG30/TI-IG60
Table of Content English 1. Before You Start 2. Quick Reference 3. Hardware Installation 4.
Package Contents Ÿ TI-IG30/TI-IG60 Ÿ Quick Installation Guide Ÿ Removable terminal block Ÿ DIN-rail mount Ÿ Wall mount kit Minimum Requirements Ÿ Existing network Ÿ Power Supply (TI-S12048) 2. Quick Reference TV-IP450PI TI-S12048 РУССКИЙ ESPAÑOL DEUTSCHE FRANÇAIS ENGLISH 1.
The PoE+ injector can be placed on a desktop, wall, or mounted to a DIN-Rail. DIN-rail Mounting Instructions ENGLISH 3. Hardware Installation РУССКИЙ 2. Position the unit in front of the DIN-Rail and hook the mount bracket over the top of the rail. 3. Rotate the fiber converter downward towards the rail to lock it into place. You will know it is secure when you hear the click. ESPAÑOL DEUTSCHE FRANÇAIS 1. Attach the DIN-Rail mount to the PoE+ injector. Mounting the unit Releasing the unit 4.
ENGLISH РУССКИЙ ESPAÑOL DEUTSCHE FRANÇAIS Wall Mounting Instructions 1. Attach the wall mount plates to PoE+ injector. 2. Mount the switch. Safety Note ! Ÿ Turn off the power before connecting any module or wire. The correct power supply voltage (48 - 56 V DC) is listed on the product label. Check the voltage of your power source to make sure that you are using the correct part. Do NOT use voltage greater than 48 - 56 V DC, the product label.
ENGLISH FRANÇAIS ESPAÑOL DEUTSCHE Applying Power 1. Connect the power supply (sold separately) to the included terminal block (as shown below) and secure with the screws. Note: Polarities must match. 2. Attach the terminal block to the unit, connect the neutral wire to the ground, and supply power to the power adapter. +V2- РУССКИЙ +V1- 3. Connect a network source and devices to the switch. Check the LEDs to confirm the connections are established. Your installation is completed.
ENGLISH 4. Additional information DIP Switch (TI-IG60 ONLY) ON OFF 1 FRANÇAIS 2 3 ESPAÑOL DEUTSCHE 4 Dip 1 Dip 2 РУССКИЙ Dip 3 Dip 4 2P 2 pair 30w 4P 4 pair 60w A Mode A End-Span is selected (Default) B Mode B Mid-Span is selected HI High power 36w at IEEE802.
Manufacturer’s Name and Address TRENDnet, Inc. 20675 Manhattan Place Torrance, CA 90501 USA Product Information: TI-IG30 / TI-IG60 Model Number: Product Name: Hardened Industrial 30 Watt Gigabit PoE+ Injector Hardened Industrial 60 Watt Gigabit PoE+ Injector Trade Name: TRENDnet TRENDnet hereby declare that the product is in compliance with the essential requirements and other relevant provisions under our sole responsibility.
Limited Warranty TRENDnet warrants its products against defects in material and workmanship, under normal use and service. Specific warranty periods are listed on each of the respective product pages on the TRENDnet website. Garantie Limitée TRENDnet garantit ses produits contre les problèmes de matériel ou de fabrication, dans des conditions normales d'utilisation et de service. Les périodes de garanties précises sont mentionnées sur chacun des pages produits du site web de TRENDnet.
Certifications This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received. Including interference that may cause undesired operation. Waste electrical an electronic products must not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or Retailer for recycling advice.
