Quick Installation Guide

ENGLISH
FRANÇAIS
DEUTSCHEESPAÑOL
РУССКИЙ
Wall Mounting Instructions
1. Attach the wall mount plates to PoE+ injector.
2. Mount the switch.
3
Safety Note
Ÿ Turn off the power before connecting any module or wire. The correct power supply voltage
(48 - 56 V DC) is listed on the product label. Check the voltage of your power source to make
sure that you are using the correct part. Do NOT use voltage greater than 48 - 56 V DC, the
product label.
Ÿ Calculate the maximum possible current in each power wire and common wire. Observe all
electrical codes dictating the maximum current allowable for each wire size. If the current
surpasses the maximum ratings, the wiring could overheat, causing serious damage to your
equipment.
!