1.
3. Hardware Installation E *The TI-UF11SFP can be placed on a desktop, wall, or mounted o 2 DIN-rail. "DIN-rail Mounting y 1. Attach the DIN-rail mount bracket to the media converter. 2. Position the unit in front of the DIN-rail and hook the mount aver the top of the rail. 3. Rotate the media converter downward towards the tall to lock It Into place. You will know It Is secure when you hear the click. Counting the unk Reloading the unk 4.
Wall Mounting Instructions 1. Attach the wall mount plats to the media converter. 2. Mount the unit. »Tum off the power forbears connecting any module or wire. The correct power supply voltage {48-56V DC) is listed on the product label. Check the vantage of your power source to make sure that you are using the correct part. Do NOT use voltage greater than 48-56V DC, as specified on the product label. «Calculates the maximum possible cement in sash prows wits and comment wits.
Applying Power E 1. Connect the power supply (sold separately) to the Included terminal bock (as shown below) and secure the screws. Mots: Polarities must match. 2. Attach the terminal block to the unit, connect the Neutral, Load and Ground o power supply. 3. Connect your Hemstitch cable, Install an SFP module, and connect a fiber cable to the media converter. Check the LED 1o confirm the connections are established. Your installation is completed.
Declaration of Conformity TREND NET Manufacturer's Name and Address ‘Trend net, Inc. 20675 Manhattan Place Torrance, CA 90501 USA Sequestrate 156 2587 WB The Hague The Netherlands Proust Information: Model Number: TI-UF115FP Product Name: Industrial SFP to Gigabit UPON Media Converter Trade Name: Trend net Trend net hereby declare that the product Is In compliance with the essential requirements and thee relevant provisions under our sole responsibility.